The Universal T-board must be installed to function properly. Below, you will find explainations and examples of part of the installs. Soldering is required and we recommend having the board installed for you if you are not comfortable with installing it yourself.

The Main Connector
(Clapper Example A, EP noid Example A, Closed bolt Example A)


(Clapper Example B, EP noid Example B, Closed bolt Example B, Closed bolt Example B with Relay)



TYPE B

Membrane pad Example

Dye membrane connection:
Yellow - Power Button
Orange - Common (for membrane pad)
Green - Eye Button (setup)


Trigger Example

Trigger switch:
White - Trigger sense (NO pin) (NC pin for A-5 E-grips)
Black - GND (common pin)


Option:
Orange - 5V (when board is on, 100MA max load)


LED Example



LED:
Brown - Common Cathode
Green - Green Pin
Red - Red Pin
Blue - Blue Pin


Battery Example (With 6800uF Cap for Clapper noid)

Power:
Red - 9-12VDC power
Black - GND


Eyes (IR) Example

Pre-wired IR Breakbeam eyes to Universal T-board wires

IR LED (Clear)
-Black wire (Positive) to Yellow (Eye LED Positive)
-Blue wire (Negative) to Black (Eye LED GND)
Phototransistor (Dark)
-Black wire (Positive) to Green (Phototransistor negative)
-Brown wire (Negative) to Orange (Phototransistor positive)

Eyes (Colored) Example

Pre-wired Colored Breakbeam eyes to Universal T-board wires

Colored LED (Clear)
-Colored wire (Positive) to Yellow (Eye LED Positive)
-Black wire (Negative) to Black (Eye LED GND)
Phototransistor (Clear)
-Brown wire (Positive) to Green (Phototransistor negative)
-Black wire (Negative) to Orange (Phototransistor positive)





Solenoid Example

EP valve (recocking valve/DM noid):
Orange - Positive for EP noid
Blue - Negative for EP noid

Clapper/ION solenoid:
Red - Positive for noid
Brown - Negative for noid


NOTE: On the Open-Bolt Universal T-board, the Solenoid and EP Valve BOTH fire. So you do not have to make any changes for a marker that uses a clapper noid (Spyder/Wrath) and one that uses an EP valve (Fusion/DM). And you can use the Solenoid wires for an EP valve. Just lower the dwell until you get the performance you like.

Connector Example